[ Chinese wardrobe network ] With the improvement of living standards, people's requirements for interior decoration are getting higher and higher, not only to be aesthetically pleasing but also convenient to use, which brings benefits to our life, so we will inevitably have a decoration. The confusion of choice, I don't know how to choose, but Xiaobian's favorite is to hang the sliding door wardrobe , Xiaobian Xiaobian will introduce the sliding door wardrobe for everyone. Hanging sliding door wardrobe design renderings First, the sliding door wardrobe installation first check If the door frame of the sliding door wardrobe is opened between the door and the wall, carefully check whether the goods and parts are intact. Take out the door frame and place the front side of the data as far as possible to avoid scratching. The floor is best covered with cardboard or carpet. Put the upper sliding wheel into the upper chute in the correct order, assemble the frame and the horizontal frame correctly and tighten with the half-section self-tapping screws. It is especially clarified that the upper sliding wheel must pay attention to its orientation and avoid the appearance of rework. Second, the hanging door wardrobe position The installed sliding door wardrobe is placed in the door opening. Firstly, the left and right door frames are horizontally sealed and straightened, and the holes are positioned and fixed by the expansion screws. If the gap is too large, the thin plate or other objects are stuffed inside. If there is a louver, it should be ensured that the level is slow and straight, the square is above the guide rail, and the hole is fixed with the expansion screw. After the sliding window is fixed, the slot on the door and the lower frame of the air window are fixed by screws. The door leaf without the air window is directly on the upper part. The appropriate orientation of the chute is perforated with a drill and fastened with a top wire. Once again, adjust the entire door frame to the left and right, fine-tune up and down to the same plane and keep straight, then tighten all the screws. Third, the height of the sliding door wardrobe Is it at the same height and is consistent with the height of the site? If it is flat, the door leaf can be hung. If it does not match, adjust to the appropriate position and then hang the door leaf. After the door leaf is hung up, adjust the horizontal condition of the pulley again, and use the lock and lock. The positioning wheel is prepared after being accurate. In the natural straight state of the door, determine the orientation of the door positioning wheel, draw the line, remove the door leaf, and fix the positioning wheel by the correct screw of the positioning wheel. Fourth, the sliding door wardrobe is cleaned after installation Hanging the sliding door wardrobe and hanging the door leaf to detect whether the gap between the two doors of the hanging sliding door wardrobe is uniform from the top to the bottom. If the unevenness is properly adjusted to the appropriate orientation and the level of the door leaf is tested, the action and the lock are smoothly and safely opened until the door is opened. After all the best functions are reached, remove the door leaf, tighten the positioning wheel screws, hang the door leaf again, and tighten the upper sliding wheel positioning adjustment screw. The devices are basically completed, and all the holes are covered with plugs, and the self-spraying wax is sprayed on the upper sliding wheel and the lock to reduce the noise and increase the slip, and clean the appearance and the surrounding area. The above is the installation method of the sliding door wardrobe introduced by Xiaobian. The sliding sliding door wardrobe is practical, convenient and beautiful. It is the best choice for our home decoration, so we have a certain understanding of the installation method of the hanging sliding door wardrobe. Very good things, this will be very convenient when we install the sliding door wardrobe in our own home. The serious of ladder tape is used for airtain,we can product these about the width between10mm-40mm. Ladder Tape WUXI MIFUN INTERNATIONAL TRADE CO.,LTD , https://www.mifunblinds.com