Question: Please explain in detail what is the difference between FM and AM in the printing process, its hardware and software? Answer: In fact, I have received a lot of questions about this. In the past two or three years, many people are very concerned about what special process is required for the FM network. Then I can tell everyone very responsibly that there is no special process for the FM network. The only thing that the FM network needs to pay attention to is the two words: stability. This stability depends on our printing equipment and the state of the entire printing press. Here are our consumables, blankets, ink and fountain solution. Perform a standardized management of these things every day. This is a key place where the FM network is capable of printing. Supplement: Mainly still stable, we provide you with standard tools, as long as you are stable, we can do a variety of standardized production, but the premise of standardization is stability. In fact, the biggest problem in China is stability. Supplement: There is a little misunderstanding about the FM network, that is, the FM network can be produced by offset printing, but why the FM network is often not applicable to the conventional printing process and then to offset printing. The reason is that everyone does not understand the standard of the traditional printing, I am the standard, the standard stipulates: the dots with a diameter of 25 microns should be transferred to the printing plate, and the dots with a diameter below 25 microns cannot be guaranteed. Many FM networks have a dot diameter less than 25 microns, or even only ten microns. Under such circumstances, the traditional printing is gone, so many of our conventional film-making printing is impossible. In this way, CTP is pushed to the front end again. If you do not have CTP technology, then it is difficult for you to actually use the FM network. liquid foundation,bb foundation cream,cc cream foundation,best liquid foundation Zchoise Cosmetic Factory , https://www.gzzchoise.com