Soft die-cutting circular press circle to replace the triple vehicle feasibility

As a die-cutting method in the molding process of corrugated cartons, triple car is favored by carton manufacturers because of its low cost. However, due to its easy cutting edge during the die-cutting process, the cartons have a certain quality risk and reduce the quality. The quality of the carton. In recent years, the circular press soft die cutting process has been widely practiced in the carton industry because of its rapid single change and smooth cutting edge, which is generally recognized by carton manufacturers. However, due to the high cost of the production of die-cutting plates, it is often the case that some small-volume orders can only be stunned.

If the above two die-cutting methods are combined, they can both effectively and clearly identify quality problems and reduce costs. Through thinking, it is suggested that we can make an adjustable round die-cutting die plate, and install the die-cut die-cutting die on the die-cutting plate carrier. The adjustable template can adjust the length and width of the carton. The two carriers can be used. The height of the carton is adjusted, and at the same time, the puck can handle the vertical carton line. In this way, we can carry out the soft die-cutting process regardless of the specifications of the small-batch order cartons. In the full-size die-cutting for large-volume orders, we can remove the bulk carrier and use the pressure roller to the side to be able to use it like the existing round press.

As shown below:

Source: Corrugated Box