[ Zhonghua Wardrobe ] Shiniman Wardrobe is a wardrobe produced by Guangzhou Shiyi Furniture Co., Ltd. The company was founded in 2003. Its design and production of Shi Nieman Wardrobe is one of the founding brands of custom wardrobes in China. The Shi Niman production base is located in Panyu, Guangzhou. It covers an area of ​​more than 120 acres and has a German Hammer production line. It is fully automated, numerically controlled, and has a production capacity that is in line with international standards. So what are the Siniman wardrobe materials? How about the Shi Nieman wardrobe It is rated as the quality and safety superior to the best products of Baijia assured enterprises, selected for quality, service, and reputation AAA enterprises, and the products have obtained the China Green Environmental Protection Product Certificate. The international standard E1 environmental protection sheet (the national standard is E2 grade) is selected to ensure indoor air health. The surface of the board is made of imported high-grade panel paper and melamine resin. It will never fade, the effect of wood grain is realistic, and the touch has obvious relief effect. Shi Nieman Wardrobe Material The Poiniman wardrobe material is made of European standard E1 grade board, which is higher than the national standard E2 grade. It is only 0.6mg/L by the national environmental protection product quality inspection center, lower than the European standard E1 grade, and the formaldehyde content is ≤1.5mg. /L. Therefore, there is no problem in the environmental protection of the board. Shi Nieman wardrobe installation 1. Use a mat to place the floor. Start by assembling the wide side panel against the end of the wall. Place the wide side panel on the ground (maintain 700mm away from the rear wall). First, put the plate of the filled three-in-one rubber plug on the cloth, check the hole spacing and the drawing, and install the three-in-one single-link. Then the solid layer is nailed to the cork, fixed on the wide side plate, the top handle with the large handle hole facing upward, the other solid layers are facing downward, and the foot line large handle hole is facing inward (the middle solid layer is consistent with the L frame height, that is, the bottom plate to the solid layer The inner space is 960mm, and the hole is drilled on site.) 2, nail back board. Place the assembled whole cabinet on the floor of the point cloth, and lay the side panels in the same plane. Use a slider to measure the diagonal size of the cabinet and adjust it to the same level. Start with the first backing plate from the wide measuring board. Note that if there is a solid nail in the middle, draw the center line of the solid layer with a pencil and nail it. nail. 3. Installation of the L frame. Use the side plates of the L frame to have a parallel line on the corresponding side plates, then move the center line of the three-in-one rubber particles up by 9 mm, and draw a parallel line on the corresponding bottom plate with the top frame of the L frame. The inner center 9mm draws the center line of three rubber pieces. The hole was drilled with a 10 mm drill bit and the hole depth was 10-20 mm.
UPLIFTEC is manufacturer and distributor of linear actuators and linear motion control products worldwide. We have over 7 years of experience in the industry. We have developed and designed a wide range of products to match the growing demand for automation across industries. We also have a great collection of motion control systems for all our linear actuators that can be easily connected to customers units and equipments. Our high quality actuator products have been used specific in particular projects such as an automated door, remote control system, mobile applications, automated furniture for smart houses much more.
Linear Actuator,Electric Linear Actuator,Motorized Linear Actuator,Heavy Duty Linear Actuator Suzhou Uplift Intelligent Technology Co., Ltd , https://www.uplifting-desk.com
