The first thing to look at the color of the board Pick the popular colors that you like, and look at the production process carefully, including the edge banding. The structure of the furniture is reasonable. The hardware used mainly focuses on the durability factor. It is recommended that you look at the cross section of the furniture sheet. The surface is not equal. Good inside, the really environmentally friendly sheet is made of fresh wood, so you can see the white fresh substrate after cutting, the particles are bigger. The second is to watch Environmentally friendly furniture should have no irritating taste and does not irritate the eyes, nose or throat. The main reason is the amount of formaldehyde released. The lower the content of formaldehyde in environmentally friendly panel furniture, the better, but the lower the better, the better the strength. It is recommended that you look at the certificate presented by the manufacturer at the same time as the product, and the promised formaldehyde content should be tested by the manufacturer to the authoritative organization for the furniture that is not at ease. It is difficult to distinguish whether the panel furniture uses paper veneer or wood veneer. The easiest way is to observe the pattern, the wood veneer has natural thrift, chromatic aberration and texture changes. The veneer is divided into melamine veneer, solid wood veneer, cat's eye paper veneer, fireproof veneer and so on. Among them, the melamine veneer is scratch-resistant, high-temperature resistant, and water-resistant, and has a strong three-dimensional texture. The style of solid wood leather finishes is diverse, and the solid wood furniture looks like a high-end. Cat's eye paper finish and fireproof board finish are relatively low-end finishes, and cat's eye paper finishes are cheap but practical, and fireproof finishes are less environmentally friendly due to construction reasons. Sealing should pay attention to the advantages and disadvantages of the edge sealing material, pay attention to whether the edge sealing is uneven or lifted. Special advice on furniture is whether it is sealed on all sides - although formaldehyde-free adhesives are used, the wood-based panels are more or less volatile during the production process, and the edges are tightly sealed. Of course, it is good for environmental protection in the living room. The degree of firmness is the gap between the door seam and the drawer of the furniture. If the gap is large, it means that the work is rough, and the time will be deformed. Second, it is a single box or a double box. Usually, in addition to the outer layer, the furniture There should also be a layer of panels inside. This is called a double box. The furniture in the double box is both beautiful and strong. Are there any streaks in paint? Is the pigment in the corner position too thick? Are there cracks or bubbles? These are all to be carefully reviewed. Also ask the salesperson, a few paints on the furniture. Of course, the more times you have, the better. The hinge groove can be seen from the hinge groove and the eye-opening. The plate furniture is medium density or particleboard. One of the best methods is to carefully observe the hinge groove and the eye-opening area. Where the internal structure is exposed, it can be seen that it is used. The particleboard is also a medium density board. The use of hardware hardware, free to disassemble and assemble is the biggest advantage of panel furniture, so the quality of the connector is closely related to the quality of the entire furniture. The quality of the hardware depends on whether it has been verified. The imported brands also have poor quality products. Square Table,Coffee Table,Metal Patio Table,Bistro Folding Table Hangzhou Doyen Mechtronic Co.Ltd , https://www.doyenhz.com
Shopping tips